Log In  


Every time i try to Copy using Ctrl-C in the Pico-8 editor on my Raspberry Pi it quits to the command prompt. Could it be reading it as the command line kill process shortcut? Im pretty sure i was able to copy using this shortcut before but even after a reboot it wont work now.

Any Ideas? Thanks.

1


I have the same behavior here...
SIGINT is not catched so I learnt to push one key at a time...
O_o"


hmm. still annoying, but ill try that.

I have also noticed that, during a session, after some amount of time (or reboots?) i AM able to use Ctrl-C without it closing. But each time i sit down for a session it quits on my first few attempts.



[Please log in to post a comment]