Log In  

Hiya! Took me a little while to figure out how to read from a GPIO pin on a PocketCHIP, so thought I'd put my example code here in case anybody else comes looking for the same thing I was. It's not actually very complicated, but maybe the code and the notes will save someone some time.

This example uses GPIO 6 - to use a different pin, just change the pin value accordingly e.g. GPIO 5 would be 0x5f86.

Pico-8 reads hardware pins as digital, so you're not going to get a value from them other than 0 or 255. In this example I've called these two values "on" and "off".

You might need to run Pico-8 as root by opening Terminal from the PocketCHIP home screen and typing "sudo pico8".

This example won't do anything in browser.

Cart #46515 | 2017-11-20 | Code ▽ | Embed ▽ | License: CC4-BY-NC-SA

P#46519 2017-11-20 12:46 ( Edited 2017-11-20 17:46)


[Please log in to post a comment]

Follow Lexaloffle:        
Generated 2020-05-31 05:42 | 0.015s | 4194k | Q:24